Setting Up - Calira EVS 17/16-DS/IU Mode D'emploi

-

Setting up

Remove the items packed separately (accessories) from the main carton, and
check them for completeness.
1 plug connector, 4-pole
1 plug connector, 6-pole
1 plug connector, 12-pole
2 mains supply cable, 1 m long,
assembled
Option
(not included)
Quick connector for battery "Quick power", part no. H10 432 0110 00
Temperature sensor for battery 2 part no. H10 012 0003 00
The device should be set up in a location not exposed to humidity and damp.
The setting up location must be clean, dry and well-ventilated. During opera-
tion, the housing may heat up to approx. 75 °C. Therefore maintain a minimum
clear distance of 100 mm and make sure that the ventilation slots are not cov-
ered.
The space provided for the device must not be smaller than the following di-
mensions, since a minimum all round clearance of 100 mm must be maintained.
Length: 475 mm / Width: 390 mm / Height: 215 mm
The device should be placed as close as possible to the battery, but always in a
separate box. The separate box for the device must be provided with ventila-
tion holes at the top and sides, with a total area of 5000 mm². The box for the
battery must have a ventilation hole facing towards the outside.
Attach the device securely with the four fastening screws supplied.
Important
Make sure that the ventilation slots remain unobstructed! The minimum clear
distance must be 100 mm all around! Insufficient ventilation can cause over-
heating of the device!
The device is designed for operation in ambient temperatures of up to 35 °C. If
the temperature inside the device rises due to a lack of air circulation or due to
high ambient temperature, the charging current is automatically reduced in
steps.
38
Lerchenfeldstr. 9 87600 Kaufbeuren Tél. : +49(0)8341 / 9764-0 Fax : +49(0)8341 / 67806
$% ./ ./#)% *+
1 fuse extraction pliers
5 contact pins
1 operating instructions
4 fastening screws with washers
! " #