Assembly; Setting Up - Calira EVS 38/20-DS/IU Mode D'emploi

' &

Assembly

Safety instructions
This device contains components that may
generate sparks or electric arcing!
Connecting the device to the power supply must comply with the applicable
national installation regulations.
This device contains components that may generate electric arcing and
sparks. Therefore when operating the device in a garage or a similar
location, it must be contained in a room or housing designed for this
purpose!
When using this device in caravans, mobile homes and boats, the device
and the battery must be installed with physical separation between them and
in well-ventilated boxes!
The assembly and connection of electric devices should always be carried
out by qualified personnel!
Always make sure that the power supply is disconnected! Pull out the mains
plug!
When connecting the device, use only the supplied parts and the specified
cable cross-sections and fuses!
Only use suitable and undamaged tools.
Only connect the device according to the supplied connection diagram!

Setting up

For initial set-up various auxiliary packs are available that have to be especially
ordered.
Option
(not included)
Quick connector for battery "Quick power", part no. H10 432 0110 00
Temperature sensor for battery II part no. H10 012 0003 00
The device should be set up in a location not exposed to humidity and damp.
The setting up location must be clean, dry and well-ventilated. During
operation, the housing may heat up to approx. 75 °C. Therefore maintain a
! "# $
Lerchenfeldstr. 9 87600 Kaufbeuren Tel.: +49(0)8341 / 9764-0 Fax: +49(0)8341 / 67806
"
33
%&&