Temperature Sensor; Battery Changeover Switch - Calira EVS 17/16-DS/IU Mode D'emploi

-
$% ./ ./#)% *+
Heating and immediate light
Heating and immediate light are supplied independently of the consumer relay.
They are connected to the permanent positive (contact 4 and 10) and protected
with a 10 A fuse.
Water pump
The fresh water pump (contact 5) is supplied by the consumer relay just like
the user circuits. It is protected with a 5 A fuse. This circuit is regulated from
the control panel via contact no. 7 of the 7-pole plug (fig 4, pos 9).
Refrigerator absorber operation
Changeover switch (fig.4, pos. 5) in A - Absorber operation position.
When the engine is running, the refrigerator is supplied with power via the
generator of the vehicle. After the engine is switched off, the refrigerator relay
disconnects the refrigerator from the supply battery. The control action is via
the cable from the D+ of the generator. Thus, operating the refrigerator at 12
volt is only possible during journeys. When the vehicle is parked, the refrigera-
tor can only be run on gas or mains voltage. This prevents the supply battery
running down. This circuit (contact 6) is protected by a 15 A fuse.
Refrigerator compressor operation
Changeover switch (fig.4, pos. 5) in K - compressor operation position.
The refrigerator is supplied via the permanent positive when the main switch is
turned on at the control panel.

Temperature sensor

(fig. 4, pos. 7)
If the power supply is operated together with a temperature sensor for the sup-
ply battery, the power supply controls the charging voltage automatically de-
pending on the battery temperature. This ensures a particularly effective and
gentle charging process for the battery. When not using a temperature sensor,
the power supply controls the charging process as if the battery temperature
was 20° C. See also section on Charging process and Technical data

Battery changeover switch

(fig. 4, pos. 6)
The power supply for AGM / gel or liquid battery types will be set by this
changeover switch. This affects the charging in the post charging phase. See
also section on Charging process and Technical data
! " #
32
Lerchenfeldstr. 9 87600 Kaufbeuren Tél. : +49(0)8341 / 9764-0 Fax : +49(0)8341 / 67806