Maintenance Instructions; Procedures In The Event Of Faults - Calira EVS 17/16-DS/IU Mode D'emploi

-
$% ./ ./#)% *+
Generator operation
Please observe the methods of handling prescribed in the operating instructions
of the generator manufacturer.
The generator must operate within the parameters for a 230 V mains supply.
Do not connect the device to the generator until it is running steady, and dis-
connect it before you switch it off. The voltage spikes created during the start-
up and shut-down phases may damage the device.

Maintenance instructions

& .
Clean the device and the ventilation slots with a dry, lint-free cloth.

Procedures in the event of faults

The device is maintenance-free. However, if any faults do occur, please pro-
ceed according to the following table:
Fault Action
The device is not Check the circuit breaker and the mains connection.
working.
The battery is not Check the battery connection, ensuring correct polarity.
being charged. Unplug the mains plug of the device and reinsert it.
12 V circuits are Check the fuses and replace them if necessary.
not being supplied. Check the connections to the affected circuits.
The voltage of the Start the motor and let it run for approx. 30 seconds.
battery 2 has Battery voltage rises above 1.5 volt. The charging proc-
dropped below ess starts automatically.
1.5 volt.
The device is The thermal switch was triggered. Wait for a few minutes
overheating and is until the device has cooled down.
not working.
! "
Lerchenfeldstr. 9 87600 Kaufbeuren Tél. : +49(0)8341 / 9764-0 Fax : +49(0)8341 / 67806
.
# 47