Skil PWRCORE 20 DL6293B-00 Guide D'utilisation page 16

Integrated Bit Clip (Fig. 10)
Your tool is equipped with an integrated bit clip
located on the back of the tool. Use the bit clip
to conveniently store hex bits.
Strap Fixing (Fig. 10)
Strap fixing is provided to attach a wrist strap
(not included) in order to reduce the chances of
dropping your tool. Wrap the strap around your
hand when carrying the tool.
Drill Bits
Always inspect drill bits for excessive wear. Use only bits that are sharp and in good condition.
Twist Bits: Available with straight and reduced shanks for wood and light-duty metal drilling.
High-speed bits cut faster and last longer when drilling hard materials.
Drilling (Fig. 11)
WARNING
with side shields during power tool
operation or when blowing dust . If the
operation is dusty, also wear a dust mask .
a. Check that the direction-of-rotation selector
is at the correct setting (forward or reverse).
b. Secure the material to be drilled in a vise or
with clamps to keep it from turning as the drill
bit rotates.
c. Hold the drill firmly and place the bit at the
point to be drilled.
d. Squeeze the trigger switch to start the drill
driver.
e. Move the drill driver bit into the workpiece, applying only enough pressure to keep the bit
"biting". Do not force the drill driver or apply side pressure to elongate a hole. Let the tool do
the work.
f. When drilling hard, smooth surfaces, first use a center punch to mark the desired location of
the hole. This will prevent the drill bit from slipping off-center as the hole is started.
g. When drilling metals, use light oil on the drill bit to keep it from overheating. The oil will
prolong the life of the bit and increase the drilling action.
h. If the bit jams in the workpiece or if the drill driver stalls, stop the tool immediately. Remove
the bit from the workpiece and determine the reason for jamming.
There are two rules for drilling hard materials. First, the harder the material, the greater the
pressure you need to apply to the tool. Second, the harder the material, the slower the speed
should be. If the hole to be drilled is fairly large, drill a smaller hole first, then enlarge to the
required size with a larger bit; it's often faster in the long run than drilling a larger hole initially.
16
Always wear safety
goggles or safety glasses
Fig . 10
Bit Clip
Fig . 11
Strap Fixing