Microscope Assembling - Optika Italy B-810 Serie Manuel D'instructions

7.1 Microscope assembling
1. Insert the optical head above the stand and
tighten the screw. (Fig. 1)
• Hold the head with one hand during the locking
in order to avoid that the head falls.
2. Insert both eyepieces into the tubes of the optical
head. (Fig. 2)
3. Insert the condenser under the stage. Check that
it is correctly inserted in its housing (under the
condenser there is a plug that must completely
enter into the guide of the condenser holder).
(Fig. 3)
4. Tighten the condenser fixing screw ①.
5. Screw each objective into the thread of
the nosepiece,
magnification. (Fig. 4)
clockwise with increasing
Page 9
Fig. 1
Fig. 2
①
Fig. 3
Fig. 4