Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4
Gas Cylinder
Use only gas cylinders, which meet national and regional codes. The minimum cylinder size for butane units is
13kg, and for propane units is 6kg. Ensure that the cylinder can provide enough fuel to operate the appliance. If
in doubt, check with your local gas supplier.
•
Use caution when handling the cylinder valve.
•
Never connect a cylinder, which does not meet local codes.
•
All cylinders 7kg or larger must be placed outside the enclosure (under the right side shelf) on level
ground. Cylinders smaller than 7kg may be placed inside the enclosure, in the hole in the bottom shelf.
Only cylinders connected to the appliance may be stored in the enclosure, or close to the appliance. Spare
cylinders must not be stored in close proximity of an operating unit. Cylinders must not be exposed to
extreme heat or direct sunlight.
WARNING!
Hoses that contact high temperature surfaces may melt and leak, causing a fire.
Cylinder Connection: Ensure that the gas regulator hose is kink free. Remove the cap or plug from the cylinder
fuel valve. Tighten regulator to cylinder valve. Leak test all joints prior to using the barbecue. A leak test must
be performed annually, and each time a cylinder is hooked up, or if a part of the gas system is replaced.
Gas Hose
•
If the hose and regulator are not included by the manufacturer, then only hoses and regulators which
meet national and regional codes are to be used.
•
Do not connect the appliance to a permanent gas installation.
•
Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces on
the appliance.
•
Check hose regularly. In the case of rips, melting or wear, replace hose before using the appliance.
•
The recommended hose length is 0.5m. The hose must not be longer than 1.5m.
•
Ensure that the hose is twist and kink free when installed.
•
Replace the hose before expiry date printed on the hose.
www.napoleongrills.com
Ensure that the hose is routed to maintain proper clearance to the underside of the unit.
Publicité
Table des Matières
