Igniter - England's Stove Works 25-CBPAH Guide D'installation Et D'utilisation

Igniter
 Before beginning any component replacement, be certain the unit is unplugged and
thoroughly cooled down.
 Remove the rear panel of the unit, using a
 Locate the igniter as shown in the diagram below.
 Disconnect the igniter wiring from the control board and use a
two igniter retaining screws that fasten the assembly to the stove. Remove the assembly
from the stove.
 Loosen the Allen set screw (
igniter cartridge.
 Install the new igniter in the igniter tube, retighten the set screw and reinstall the assembly
into the stove (remember to reconnect the wiring).
 Reinstall the rear panel.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING COMPONENTS
1
/ " Allen wrench) from the igniter tube and remove the old
8
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
5
/ " wrench.
16
37
5
/ " wrench to remove the
16