Cleaning The Burn Pot - England's Stove Works 25-CBPAH Guide D'installation Et D'utilisation

 Because of the open design of the firebox, the majority of the ash will be on either side of the
cradle. Open the door of the stove and use an old paint brush or putty knife to move ash from
around the burn pot and into the open areas beside the cradle.
 Using the cleaning tool provided, remove any deposits left in the burn pot, being careful to
remove them from the burn pot and not allow them to filter down into the cradle area.
Excessive ash build‐up in the cradle can cause poor stove performance (See "Cleaning the Burn
pot," below).
WARNING: Use caution when using the
cleaning tool, as it has a sharp point and may
have some sharp edges (as with any metal
tool). As we recommend with any
maintenance, use gloves, safety glasses and
any necessary safety apparel when handling
the cleaning tool.
Cleaning the Burn Pot
Along with removing ashes from the stove,
cleaning the burn pot is the other essential part of daily maintenance that will keep the stove
operating at its peak. Pellets contain varying amounts of impurities and fusible material that will
accumulate in the burn pot over time. Some pellets will contain much higher amounts of these
fusible impurities, therefore extra vigilance may be required to maintain a clean burn pot. Allowing
impurities to build up in the burn pot can restrict the air flow to the fire, resulting in a dirty, inefficient
burn and can shorten the life of the burn pot.
NOTE: The burn pot should be cleaned out before each start‐up (before pressing the ON
button), and daily.
 Always allow the stove to finish the shut‐down cycle and cool completely before performing
any maintenance inside the firebox.
 Open the front door and remove the burn pot by lifting it straight up and out of the cradle.
WARNING – The burn pot can remain HOT long after the fire has gone out, so wear protective
gloves whenever handling a potentially hot burn pot.
 Once the burn pot is out of the stove, use the cleaning tool to remove any deposits from the
inside of the burn pot.
 Be certain all air holes are clear and unrestricted by fusible ash matter; the cleaning tool
provided is designed to fit these holes and will be useful in removing stubborn deposits from
these holes.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
Cleanout
Cover
24
Cleanout
Cover
Burn
Pot