Horizon Hobby ARRMA INFRACTION 6S Mode D'emploi page 12

Radio Gear Fernsteuer Ensemble radio Equipo de radio
SPEKTRUM DX2E ACTIVE RADIO SYSTEM
9
8
7
6
5
4
3
Aux channels
The Aux channels can operate as additional servo channels, or as a power supply for a personal transponder.
If AVC is active, only 4 channels; Steering, Throttle, AUX3 and AUX4 are operational. The remaining Aux channels can be used to power a personal transponder or lights.
If AVC is disabled (see DISABLING THE STABILITY ASSIST FUNCTION), all 6 channels (including the Aux channels can operate as servo channels).
BINDING/CALIBRATING THE RECEIVER
Binding
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier)
code of a single specific transmitter. When a receiver is bound to a transmitter/model memory, the
receiver will only respond to that specific transmitter/model memory.
Your Spektrum DX2E transmitter comes prebound to the vehicle. If you need to
rebind or calibrate, follow the instructions below.
1. With the vehicle on a flat, level surface, insert the Bind Plug in the BIND port on the receiver.
2. Connect a fully charged battery pack to the ESC.
3. Power on the ESC. The orange LED flashes on the receiver, indicating it is in bind mode.
4. Center the ST TRIM and TH TRIM dials on the transmitter.
5. Press and hold the BIND button while powering on the transmitter.
6. Release the BIND button when the orange LED slowly flashes. The transmitter and receiver
are linked when the orange LED is solid.
Calibrating (continue from step 6 above)
1. Pull the transmitter trigger to Full Throttle, the orange LED will flash once.
2. Push the transmitter trigger to Full Brake, then return the trigger to center.
3. Turn the transmitter steering wheel to Full Right. The orange LED flashes.
4. Turn the transmitter steering wheel to Full Left, then return the steering wheel to center.
The orange LED flashes once.
5. Remove the Bind Plug, then power off the receiver to save the settings.
6. Power off the transmitter.
TRANSMITTER FUNCTIONS
10 11
12
1
2
FUNKTIONEN DES SENDERS
FUNZIONI DELLA TRASMITTENTE
1. Steering Wheel Controls direction (left/right) of the model
13
2. Throttle Trigger Controls speed and direction (forward/brake/reverse) of the model
3. BIND Button Puts the transmitter into Bind Mode
4. On/Off Switch Turns the power ON/OFF for the transmitter
5. TH REV Reverses function of the speed control when pulled back or pushed forward
6. Indicator Lights
- Solid green light—indicates adequate battery power
- Flashing green light—indicates the battery voltage is critically low. Replace batteries
7. ST REV Reverses the function of the steering when the wheels is turned left or right
8. ST Trim Adjusts the steering center point
9. TH Trim Adjusts the throttle neutral point
10. TH Limiter Limits throttle output to 50, 70 or 100%.
11. 3-Position Switch Used to control a third channel and is preset at -100%/Neutral/100%
12. ST Rate Adjusts the sensitivity of AVC technology
13. Antenna Transmits the signal to the model
SRS6000 AVC TECHNOLOGY RECEIVER
Bind/Battery
Aux 4/Disable
Aux 3
Aux 2
Aux 1
Throttle
Steering
12
FONCTIONS DE L'ÉMETTEUR
Antenna
Forward
Brake/Reverse
WWW.ARRMA-RC.COM