Antari W-715 Mode D'emploi page 7

Duration Time Setup - Press the [Menu] button until the LCD screen displays "Duration
Set" and press the ▲ or ▼ button to set the duration time from 2-15 seconds.
Output Volume Setup - Press [Menu] until the LCD screen displays "Timer Output" and
press the ▲ or ▼ button to set the output percentage from 50-100%.
After finishing the above setting, go back to the main screen by pressing the [Stop] button.
To activate Timer Mode, press the [Timer] button below the display. To deactivate Timer
Mode, press [Stop] button.
Volume Operation
To operate the machine in Volume Mode, the output volume under Volume Mode must be
set first:
Output Volume Setup - Press the [Menu] button until the LCD screen displays "Volume
Output" and then press the ▲ or ▼ button to set the output percentage from 50-100%.
After finishing the above setting, go back to the main screen by pressing the [Stop] button.
To activate Volume Mode, press the [Volume] below the display. To deactivate Volume
Mode, press the [Stop] button.
Note: In Volume Mode, the machine emits fog continuously until a re-heat is needed.
2-Second Jet Operation
To activate 2-Second Jet Mode, press the [Menu] button until the LCD screen displays
"2-Second Jet Output" and then press the ▲ or ▼ button to activate or deactivate
2-Second Jet Mode. Once the 2-Second Jet Mode is activated, the main screen will keep
showing "2-Sec Jet Mode". Press the [Volume] button and the fog will be emitted for 2
seconds with maximum output (100%).
DMX Operation
Making the DMX Connection – Connect machine to a DMX controller or to one of the
machines in the DMX chain. The machine uses an 3-pin and 5-pin XLR connector for DMX
7