Checking The Water Dispenser Line(Optional); Installing The Water Dispenser Line - Atag KA2211DC Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. After adjusting the doors, turn the nut
bolt, then tighten the bolt again with the wrench
If you do not secure the nut firmly, the bolt may release.
CHECKING THE WATER DISPENSER LINE (
A water dispenser is just one of the helpful features on your new refrigerator. To help promote better health,
the water filter removes unwanted particles from your water. However, it does not sterilize or destroy
microorganisms. You will need to purchase a water purifying system to do that. In order for the icemaker to
operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc paper cup
can be filled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below 138 Kpa),
you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside
the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water
outlet.
Water Line installation Kits are included with. You can find it in one of the freezer drawer.

INSTALLING THE WATER DISPENSER LINE

Parts for water line Installation
1
Connecting to the water supply line
1. first, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
3. follow the Water line Installation Instructions in the
installation kit.
4. After connecting the water supply to the water filter, turn your main water supply back on and
dispense about 1l to clear and prime the water filter.
1
clockwise
3
to fix the nut in place
2
until it reaches the lower end of the
1
3
2
1
(
OPTIONAL)
)
3
The water line must be connected
to the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifier to malfunction.
4
_19
setting up

Publicité

Table des Matières
loading

Table des Matières