Controls And Displays; Operating And Control Elements; Temperature Display; Putting Into Operation - Atag KD80140CDN Mode D'emploi

Controls and displays

Do not misuse the plinth, drawers, doors etc.
-
as a step or for support. This applies particu-
larly to children.
Danger of food poisoning:
Do not consume food which has been stored
-
too long.
Danger of frostbite, numbness and pain:
Avoid lasting skin contact with cold surfaces
-
or refrigerated/frozen food or take protective
steps, e.g. wear gloves. Do not consume ice
cream, water ice or ice cubes immediately
and do not consume them too cold.
Danger of injury and damage:
Hot steam can lead to injury. Do not use elec-
-
trical heating or steam cleaning equipment,
open flames or defrosting sprays to defrost.
Do not use sharp implements to remove the
-
ice.
Danger of crushing:
Do not hold the hinge when opening and
-
closing the door. Fingers may get caught.
Symbols on the appliance:
The symbol can be located on the compressor. It
refers to the oil in the compressor and indicates
the following danger: Swallowing or inhaling can
be fatal. This is only relevant for recycling. There
is no danger in normal operation.
Please observe the specific information in
the other sections:
DANGER identifies a situation involving direct
danger which, if not obviated, may
result in death or severe bodily
injury.
WARNING identifies a dangerous situation
which, if not obviated, may result in
death or severe bodily injury.
CAUTION identifies a dangerous situation
which, if not obviated, may result in
minor or medium bodily injury.
NOTICE identifies a dangerous situation
which, if not obviated, may result in
damage to property.
Note identifies useful information and tips.
20
3 Controls and displays

3.1 Operating and control elements

Fig. 2
(1) On/Off button

(2) Temperature display

(3) "+/-" setting button
(4) Fast-Freeze button
(5) Fast-Freeze symbol
3.2 Temperature display
- the freezer temperature setting
The temperature display flashes if/when:
You change the temperature setting
-
- The appliance is not cold enough after switching on
- The temperature rises by several degrees
The following displays indicate a fault. Possible causes and
solutions: (see Malfunction).
-
to
F0 F9
-
The power failure symbol

4 Putting into operation

4.1 Switching on the appliance

u Open the door.
u Press the On/Off button
w The appliance is switched on. The temperature display and
Fig. 2 (7) flash until the temperature is cold
Alarm symbol
enough.
w If "DEMO" is displayed, demo mode is activated. Please
contact the after sales service.

5 Control

5.1 Child proofing

The child-proofing function enables you to make
sure that the appliance is not inadvertently switched
off by playing children.
5.1.1 Setting the child lock function
Activate setting mode:
u Press the Fast-Freeze button
5 seconds.
* Depending on model and options
(6) Alarm button
(7) Alarm symbol
(8) Menu symbol
(9) Child lock symbol
(10) Power failure symbol
flashes.
Fig. 2 (1) .
Fig. 2 (4) for approx.