Atag KA2211DC Notice D'utilisation page 140

setting up your side-by-side
refrigerator
Connecting the water line to the refrigerator
1. Remove the dust cap from the water line on the rear of the unit and fit a compression nut from the
install kit.
2. Remove the water pipe from the install kit and fit a compression nut to one end.
3. Join the two pipes together using the compression joint from the install kit ensuring that the joint is
water tight.
4. Join the other end of the install pipe to the main water supply and turn on the water to check for
leaks.
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.
Before being used, the leakage in these places should be examined
delivery charge (refer to the delivery agreement with the seller)
20_
setting up