Putting Into Operation; Switching On The Appliance; Control; Child Proofing - Atag KD80122AFN Notice D'utilisation

4 Putting into operation

4.1 Switching on the appliance

u Open the door.
Fig. 2 (1) .
u Press the On/Off button
w The temperature display lights up. The interior
light goes on when the door is opened. The appli-
ance is switched on.
w If "DEMO" is displayed, demo mode is activated.
Please contact the after sales service.

5 Control

5.1 Child proofing

The child-proofing function enables you to make
sure that the appliance is not inadvertently switched
off by playing children.

5.2 Door alarm

For the fridge and BioFresh compartments
An audible warning sounds if the door is open for
longer than 60 seconds.
The audible warning stops automatically when the
door is closed.
5.2.1 Muting the door alarm
The audible alarm can be muted when the door is open. The
sound switch-off function is active as long as the door is left
open.
Fig. 2 (6) .
u Press alarm button
w The door alarm is silenced.

5.3 Refrigerator compartment

The natural circulation of air in the refrigerator compartment
results in zones differing in temperature. It is coldest directly
above the plate separating off the ClimatFreshbox zone and at
the rear wall. It is warmest at the top front of the compartment
and in the door.
5.3.1 Refrigerating food
Note
The energy consumption increases and the cooling perform-
ance decreases if the ventilation is inadequate.
u Always keep the air slits of the fan free.
u Place butter and preserves in the top area and in the door.
(see 1 Appliance at a glance)
u Use reuseable plastic, metal, aluminium, glass containers
and foil wrap to store food.
u Always store raw meat and fish in clean, sealed containers
on the bottom shelf of the refrigerator, to prevent them
coming into contact with or dripping onto other foods.
u Foods that easily absorb or give off smell or taste, as well as
liquids, should be stored in sealed containers or covered.
u Use the front area of the base shelf only to temporarily set
down refrigerated foods, for example while rearranging or
sorting the contents. Remember not to leave refrigerated
foods here as they could shift to the back or tip over when
you close the door.
u Do not pack foods too closely together, as the air needs to
circulate.
* Depending on model and options
Putting into operation
5.3.2 Setting the temperature
The temperature depends on the following factors:
the frequency of opening the door
-
- how long the door is open for
- the room temperature of the installation location
- the type, temperature and quantity of the food
Recommended temperature setting: 5 °C
An average temperature of approx. -18 °C is then established
in the freezer compartment.*
The temperature can be adjusted continually. Once the setting
3 °C is reached, the cycle is begun again at 9 °C.
u Call up the temperature function: Press the "+/-"
Fig. 2 (3) .
setting button
w The previously-set value will flash in the tempera-
ture display.
u Change the temperature in 1 °C steps: Press
the "+/-" setting button
required temperature is indicated in the tempera-
ture display.
u Change temperature continually: hold down
setting button.
w During adjustment the value flashes on the display.
w The new setting is adopted approx. 5 seconds after the
last time the button was pressed and the set temperature
is again displayed. The temperature in the interior gradually
adjusts to the new value.
5.3.3 Fast Cool
FastCool is for maximum cooling. This option is for very low
temperatures:*
- In the fridge compartment
- In the freezer compartment*
Use FastCool if you want to quickly cool a large amount of food.
To freeze food, activate FastCool when you place the goods in
the appliance.*
The fan is in operation when Fast Cool is switched on*. The
appliance operates with the maximum cooling capacity; conse-
quently, noises emitted by the cooling unit may be temporarily
louder.
Fast Cool has a slightly higher energy consumption
To cool using Fast Cool
u Briefly press the Fast Cool button
Fig. 2 (5) illuminates in the display.
w The Fast Cool symbol
w The cooling temperature drops to the coldest value.
Fast Cool is switched on.
w The freezing temperature drops to the lowest setting.*
w Fast Cool automatically switches itself off after approx. 12 h.
The appliance continues to function in the energy-saving
normal mode.
To switch off Fast Cool ahead of time
u Briefly press the Fast Cool button
w The Fast Cool symbol Fig. 2 (5) goes out in the display.
w Fast Cool is switched off.
5.3.4 Shelves
Moving or removing shelves
The shelves are prevented from being pulled out accidentally
by pull out stops.
Fig. 2 (3) until the
Fig. 2 (4) .
Fig. 2 (4) .
25