Burkert 6104 Instructions De Service page 6

The following standards were also used to assess non-electrical equipment and
equipment in the filling station area:
EN 13463-1 Non-electrical equipment for potentially explosive atmospheres
Part 1: Basic method and requirements
EN 13617-1 Petrol filling stations
Part 1: Safety requirements for construction and performance of
metering pumps, dispensers and remote pumping units.
The production of electrical equipment, for which an EC-type examination certificate
is available, is monitored by;
Physikalisch Technischen Bundesanstalt
Bundesallee 100
38116 Braunschweig
Such units are labeled with CE0102.
The EC-type examination certificate comes with the operations manual, where the
number can also be found. As a general rule, the standards found in the EC-type
examination certificate are valid.
The following standards have been used to assess the products with respect to
Pressure Equipment Directive (97/23/EG):
EN 60730-1 Automatic electrical controls for household and similar use
Part 1: General requirements
EN 60730-2-8 Automatic electrical controls for household and similar use
Part 2-8: Particular requirements for electrically operated water
valves, including mechanical requirements.
The products have been subjected to the following conformity assessment
procedure:
Modules A Internal production control.
The Pressure Equipment Directive for products with a nominal voltage < 50V is
applied to the CE mark only for equipment which has a nominal width > 25 mm
and controls gases belonging to Group 1 or vapour or controls gases belonging to
Group 2 and the product is within the range > 1,500 and < 3,500 for the calcula-
tion nominal pressure x nominal width > 1,500 and < 3,500.
6 - 01 ATEX 2173