Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
GB
PROBLEM
Dehumidifier does not start
Does not dehumidify
High noise level
Does not turn off when water
reservoir is full
No water enters reservoir
FL
E1
If none of the above works, you should contact your nearest retailer for checking and possible overhaul of dehumidifier.
TECHNICAL DATA
Max. working area
Air flow step 1
Air flow step 2
Dehumidifying at 20˚C and 70% r.h.
Dehumidifying at 30˚C and 80% r.h.
Power at 20˚C and 70% r.h.
Power consumption at 20˚C and 70% r.h.
Tank volume
Refrigerant
Charge R290
Voltage
Frequency
Current
IP-Code
Noise level in decibels
Weight
Dimensions in mm, L x Bx H
*Technical changes and improvements may occur.
All values are approximate and may vary due
to external circumstances such as temperature,
ventilation, and humidity.
14
SOLUTION
-
Check that dehumidifier is connected to electricity and that fuse has not gone
-
If the warning light is on, check that the water reservoir is empty and correctly placed in the dehumidifier.
Check that float is free
-
Check that the fan is spinning
-
Check that air can flow freely through the dehumidifier. The top grid and air filter should be clean and the dehumidifier should stand 30cm from walls.
-
Listen for sound from the compressor, but bear in mind that the dehumidifier may stop when the ambient humidity reaches the set humidity.
-
Check that a thick coating of ice has not formed on the cooling coils.
-
Increase distance between the dehumidifier and surrounding surfaces
-
Cooling coils may be in contact with one another and cause vibration. Disconnect dehumidifier from electricity and separate coils.
-
It is important that the float moves freely in the water reservoir. If it does not, it will not respond to water levels and prevent dehumidifier from stopping
-
Check for obstruction to drip-tray above water reservoir
-
Water reservoir is full. Empty the water reservoir and put it back.
- Temp-humidity sensor failure. Replace the temp-humidity sensor.
MDX14
40m
2
100m
3
/h
120m
/h
3
6,0 l/ 24h
10 l/24h
180 W
4,3kWh/24 h
1,5 liters
R290
40 g
220-240V
50Hz
1A
IPX2
43dB
9,1 kg
293x183x493
NOTE!
Register at www.warranty-woods.com
and read about how to get
extended warranty. Please visit
www.woods.se for more information.
Recommended limits for use
Temp. +5˚C to +35˚C
Relative humidity: 30% to 90%
Recommended humidity level:
appr. 50% RH
Guarantees
2 years consumer warranty against production faults.
Please note that the warranty is only valid upon the
production of the receipt. The warranty is only valid if the
product is used in accordance with the instructions and
security warnings expressed in this manual. The warranty
does not cover any damages caused by improper
handling of the product.
NOTE: The 2 years warranty only applies for consumers
and not for commercial use of the unit.
Publicité
Table des Matières
