Waste Management - Associated ESS6100 Mode D'emploi

• Wear protective goggles and gloves.
• In case of contact with the eyes or the skin, rinse immediately with
water and see a medical doctor as soon as possible.
Connection / disconnection :
• Disconnect the power supply before plugging or unplugging the
connections to/from the battery.
• Always ensure the Red clamp is connected to the «+» battery terminal
first. If it is necessary to connect the black clamp to the vehicle chassis,
make sure it is a safe distance from the battery and the fuel line. The
charger must be connected to the mains.
• After charging, disconnect the charger from the mains, then disconnect
the negative clamp from the car body and then disconnect the positive
clamp from the battery, in this order.
Connection :
• The charger must be connected to an earthed power supply.
• The connection to the power supply must be carried out in compliance
with national standards.
Maintenance :
• If the power supply cable is damaged, the replacement cable must
be obtained from the manufacturer or its service team.
• Maintenance should only be carried out by a qualified person.
• Warning ! Always disconnect from the mains before performing
maintenance on the device.
• The device does not require any specific maintenance.
• If the internal fuse is melted, it must be replaced by the manufacturer
(Associated dedicated sales service) or by an equally qualified person
to prevent any accidents.
• Do not use solvents or any agressive cleaning products.
Regulations :
• The Machine is compliant with European directives.
• The certificate of compliance is available on our website.

Waste management:

• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a household bin.
MODEL ESS6100 EN
3