Associated ESS6100 Mode D'emploi page 10

• Start of the charge:
To start the mode, press the START/STOP button.
1
If the AUTO-DETECT function is active, charging will start
automatically after 5 seconds if a battery is present.
During the mode, your ESS6100 indicates the battery voltage and the cur-
2
rent delivered by the charger.
3 Press the START/STOP button to stop the mode.
Precautions :
When starting the mode, a current displayed above 10 A means that your battery is discharged. The device will start charging
automatically Check that there is no electrical consumer on the vehicle. Wait until the current supplied drops below 10 A before
starting any action on the vehicle (use of the vehicle's electrical accessories, diagnostic operation, etc.).
Features of the power modes:
Mode «No Battery» function
SHOWROOM
DIAG+
CHANGE BAT
POWER SUPPLY
• «No battery» function (not recommended):
This function allows you to use the SHOWROOM power mode when there is no battery. To do this, press
the START/STOP button for 3 seconds. The «No battery mode» indication is displayed for 3 seconds
before forcing the power supply.
In Power Supply mode, the «no battery» function is activated permanently.
It is strongly recommended not to use the «no battery» function if a battery is present.
This function disables the «Integrated charging» function, as well as some of the protections such as
abnormal undervoltage protection or disconnection detection.
In this configuration, reverse polarity can damage the vehicle electronics.
• «Integrated charging» function:
The SHOWROOM mode (outside of the «no battery» function) incorporates an automatic charging algorithm adapted to all types
of batteries (lead and lithium), in order to guarantee an optimal charge level for demonstration vehicles. This function is perfectly
compatible with the presence of consumers on the battery.
1
U
I
Analysis
10
MODEL ESS6100
«Integrated charging»
2 3
Charging Absorption
AUTO-DETECT 12V
U=12.3V
Abnormal undervoltage
function
4
Equalization /
Complement
Balancing
SHOWROOM
U:13.7V I:9.7A
1
1- Battery voltage
2- Current delivered by the charger
Voltage adjustment
protection
6
5
Power supply mode
EN
12V
2
12.7 V - 14.4 V
12.7 V - 14.8 V
12.9 V
2.0 V - 16.0 V
SHOWROOM 12V
no battery mode