Features; Energy Conservation - Craftsman CMXEOCG322 Manuel Du Propriétaire

FEATURES

Your garage door opener is equipped with features to provide you with greater control
over your garage door operation.
myQ ® (DO NOT ENABLE ON ONE-PIECE DOORS)
®
myQ technology uses a 900 MHz signal to provide two-way communication between
®
the garage door opener and myQ
compatible with up to 8 myQ ® accessories.
FOR MODELS CMXEOCG772 AND CMXEOCG982
TIMER-TO-CLOSE (DO NOT ENABLE ON ONE-PIECE DOORS)
The Timer-to-Close feature automatically closes the door after a specified time period
that can be adjusted using the door control. Prior to the door closing there will be an
audible and visual alert.
REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener has already been programmed at the factory to operate with
your remote control, which changes with each use, randomly accessing over 100
billion new codes.
®
myQ Accessories
Remote Controls
Door Controls
Wireless Keypads
THE SAFETY REVERSAL SYSTEM
When properly connected and aligned, the safety reversing sensors will detect an
obstruction in the path of the infrared beam. If an obstruction breaks the infrared
beam while the door is closing, the door will stop and reverse to full open position,
and the opener lights will flash 10 times. If the door is fully open, and the safety
reversing sensors are not installed, or are misaligned, the door will not close from a
remote control. However, you can close the door if you hold the button on the door
control or wireless keypad until the door is fully closed. The safety reversing sensors
do not effect the opening cycle.
enabled accessories. Your garage door opener is
MEMORY CAPACITY
Up to 8
®
Up to 2 myQ door controls
Up to 1

ENERGY CONSERVATION

For energy efficiency the garage door opener will enter sleep mode when the door is
fully closed. The sleep mode shuts the garage door opener down until activated. The
sleep mode is sequenced with the garage door opener light bulb; as the light bulb
turns off the sensor LEDs will turn off and whenever the garage door opener lights turn
on the sensor LEDs will light. The garage door opener will not go into the sleep mode
until the garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged in;
power is restored after interruption, or when the garage door opener is activated. The
lights will turn off automatically after 4-1/2 minutes. An incandescent A19 light bulb
(100 watt maximum) or for maximum energy efficiency a 26W (100W equivalent)
compact fluorescent light (CFL) bulb may be used.
LED bulbs may cause remote control radio interference. Model CMXEOCG982 comes
equipped with 2 LED bulbs. We recommend use of these bulbs as replacements so
transmitter range is not reduced.
FOR MODEL CMXEOCG982
BATTERY BACKUP
The battery backup system allows access in and out of your garage, even when the
power is out. When the garage door opener is operating on battery power, the garage
door opener will run slower, the light will not function, the Battery Status LED will
glow solid orange, and a beep will sound approximately every 2 seconds.
USING YOUR GARAGE DOOR OPENER
The garage door opener can be activated through a wall-mounted door control, remote
control, wireless keypad or myQ
When the door is closed and the garage door opener is activated the door will open. If
the door makes contact with an obstruction while opening, the door will stop, opener
beeps and lights flash 5 times. When the door is in any position other than closed and
the garage door opener is activated, the door will close. If the garage door makes
contact with an obstruction while closing, the door will reverse, opener beeps and
lights flash 5 times. If the obstruction interrupts the sensor beam the garage door
opener lights will blink 10 times. However, you can close the door if you hold the
button on the door control or wireless keypad until the door is fully closed.
The safety reversing sensors do not affect the opening cycle. The safety reversing
sensor must be connected and aligned correctly before the garage door opener will
move in the down direction.
34
®
accessory.