Craftsman CMXEOCG322 Manuel Du Propriétaire page 6

PLANNING (CONTINUED)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require reinforcement. If your door is
lightweight, refer to the information relating to sectional doors in
Installation Step 8.
• Depending on your door's construction, you may need additional mounting
hardware for the door bracket (Installation Step 8).
ONE-PIECE DOOR WITHOUT TRACK
Header Wall
Gap between floor
and bottom of door must
Safety Reversing
not exceed 1/4" (6 mm).
Sensor
ONE-PIECE DOOR WITH TRACK
Gap between floor
and bottom of door
must not exceed
Safety
1/4" (6 mm).
Reversing Sensor
Rail
Wall-Mounted
Door Control
Access
Door
Safety Reversing
Sensor
Access
Door
Header
Wall
Safety
Reversing Sensor
Without a properly installed safety reversing sensor, persons (particularly small
children) could be SERIOUSLY INJURED or KILLED by a closing garage door.
• The gap between the bottom of the garage door and the floor MUST NOT
exceed 1/4" (6 mm). Otherwise, the safety reversal system may NOT work
properly.
• The floor or the garage door MUST be repaired to eliminate the gap.
Motor Unit
CLOSED POSITION
Rail Tab
Header
Rail
Bracket
Door Bracket
Straight
Door
Arm
Header
Garage
Wall
Door
CLOSED POSITION
Rail Tab Trolley
Belt
Curved
Header
Door Arm
Bracket
Door
Bracket Straight
Door
Garage
Arm
Door
6
Belt Trolley
Emergency
Release
Rope & Handle
Curved
Door
Arm
Rail
Emergency
Release
Rope &
Handle