Télécharger Imprimer la page

KTM Factory Start 85SX Instructions D'installation page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

3
15 15
Model
KTM Partnumber
65SX
SXS04065100
85SX
SXS04085100
USD 48
SXS05540100
4860 MXMA SM SXS05540100
1
2
X
„X"
45 ± 10mm
70 ± 10mm
70 ± 10mm
90 ± 10mm
2
Scope of supply:
1 x latch ring
1 x latch button
1 x M5x12 AH screw
2 x M5x5 flat-head screw
Mounting
1 Jack up the motorcycle.
2 Dismount the front wheel.
3 Dismount the right fork leg and the fork protector (in the direction
of travel).
4 Slip the latch ring [1] on the fork leg, push all the way down and
screw tight. The engaging area should point towards the front.
5 Remount the fork leg.
6 Mounting the latch button on the fork cover.
a
As a mean value, measure down from the upper edge the "X"
distance listed in the table and drill a hole with a diameter of
13.5 mm. Drill 2 additional holes 15 mm above and below the
hole with a diameter of 5mm. For the lateral alignment, measure
5 mm from the shadow edge on the front to the left.
b Countersink the two 5 mm holes from the rear until the head on
the two M5 flat-head screws disappears. Secure the M5 flat-
head screw with Loctite.
c
Screw the latch button onto the fork cover.
7 Remount the fork protection [3] .
8 Remount the front wheel.
9 Loosen the fixing screws on the triple clamp again and then screw
tight.
10 Loosen the latch ring again. The latch button on the fork cover
should be aligned with the engaging area of the latch ring. Screw
the latch ring tight again. Apply Loctite 243 to the latch ring and
tighten to 1.5 Nm.
Operation
Sitting on the motorcycle, lean forward over the handlebar, reach for
the rim and compress the fork, press the latch button [2] and slowly
rebound until the latch button engages in the latch ring. Let go of the
latch button. The latch button will automatically be released from the
latch ring when you compress for the first time while driving.
– CHECK THE LATCH BUTTON FOR SMOOTH OPERATION BEFORE
EACH USE.
– DANGER OF FREEZING UP AT TEMPERATURES BELOW 0°.
3

Publicité

loading

Ce manuel est également adapté pour:

Factory start 65sxFactory start 4860 mxma sm