Palazzetti ECOFIRE Notice D'installation page 50

10.2 STANDBY FUNCTION
During operation (i.e. when the stove is on and in steady operating conditions) the stove can be switched off
when reaching the set room temperature (SET ROOM T.) and start again when reaching the set minimum room
temperature (START TEMP.).
To enable this function, go to the "STOVE SETTINGS MENU" following the "Procedure for accessing the menus"
described in paragraph 7.3 and press
and then press
Two parameters can be set:
- The ¿ rst - ON/OFF - enables or disables the function;
- The second de¿ nes the temperature for restarting the stove.
When this function is active, the display shows the " " symbol.
"STAND-BY" is displayed when the room temperature is higher than the set "START TEMP.".
10.3 FROST PROTECTION FUNCTION
When the stove is off this function ensures the stove maintains the set room temperature (useful at night).
To access this function go to the "STOVE SETTINGS MENU" using the "Procedure for accessing the menus"
described in paragraph 7.3 and press
T." using the
This menu has just one parameter, which can be set to "OFF" (function disabled) or alternatively a temperature
value (between 3° and 20°C) representing the temperature below which the stove will start.
When this function is active, the display shows the " " symbol.
"NIGHT STAND-BY" is displayed when the room temperature is higher than the set "NIGHT SET T".
10.4 "ECONOMY" FUNCTION
This is used to set the stove's maximum operating output in automatic mode. The set power level will never be
exceeded, thus keeping fuel consumption under control.
10.5 RESTARTING AFTER A POWER FAILURE
In the event of momentary power failures, the stove will restart automatically when power returns, if the conditions
are right. If such conditions are not ful¿ lled, the display will show "Black Out Alarm" and the stove must be reset
manually as described in chapter 12.
10.6 READING THE OPERATING HOURS
The display can show total stove operating hours or the number of hours remaining before recommended
maintenance is required (to be performed by the Service Centre).
Pressing and holding the
the button will display the REMAINING HOURS for a few moments.
10.7 STARTING AND SWITCHING OFF THE STOVE USING THE REMOTE DEVICE (only
where avaiable)
After installing the remote device, the stove must be started the ¿ rst time from the control panel. Closing the
remote contact stops the stove (for example, when reaching the set temperature). The display shows "REMOTE
STAND-BY". Opening the contact starts the stove again. The function is disabled if the OFF button is pressed
(switching the stove off) in any of the following stages: AWAITING FLAME, FLAME ON, FIRE ON, REMOTE
STAND-BY.
10.8 OPERATION WITH ROOM THERMOSTAT
After having connected the room thermostat, when this is activated the stove will go to the lowest power
level (minimum output) while otherwise maintaining standard operation. The display will show the message
"THERMOSTAT ON" or alternatively the two temperature values will À ash.
10.9 "EASY CLEAN" FUNCTION
This function is used to clean the stove by reducing the amount of ash dispersed in the room.
During this operation the À ue gas fan operates at maximum speed, thus preventing ash from leaving the ¿ rebox.
It can only be activated when the stove has cooled down completely and is off.
When the stove is OFF, press the
switch off automatically after a preset cycle).
To stop the operation manually, press the
50/144
USE AND & MAINTENANCE
.
button.
button will display the TOTAL HOURS for a few moments, while pressing and holding
button for 2 seconds (the À ue gas fan will start at maximum speed and will
OFF
INSTALLATION MANUAL
. Use the arrow buttons to scroll until the display shows "STAND-BY"
. Use the arrow buttons to scroll the menu and select "NIGHT SET
button.
OFF
- cod. 004770810 - 09/2011 - Palazzetti - PN - Italy