Russell Hobbs 19000-56 Mode D'emploi page 4

13 Put the ingredients into the jug.
14 Don't fill past the 1500ml mark. If you do, the contents may force the lid off when you start
the motor.
15 Close the lid.
16 Align the pips on the cap with the slots in the hole, fit the cap, and turn it clockwise to lock it.
17 To add ingredients while the blender is working, remove the cap, pour the new ingredients
through the hole, then replace the cap.
18 Check that the added ingredients don't push the volume in the jug past the 1500ml mark.
O USING THE PROCESSOR
19 Switch the appliance off (0) and unplug it.
20 Fit the spindle to the top of the motor unit.
21 Align the d on the bottom of the jug with the U on the motor unit.
22 Lower the jug on to the motor unit, then turn the jug to align the d with the L.
23 Turn the lid to bring the d on the lid over the U on the jug, and lift the lid off.
24 Choose the attachment you need.
O WITH THE SUPPORT
25 Use the chopper for pulverizing ingredients.
26 Use the mixer to mix ingredients together.
27 Use the creamer to thicken cream, to beat eggs, and to cream eggs and sugar together.
28 Fit the attachment over the support, and slide it to the bottom.
29 Lower the support into the centre of the jug, over the spindle.
30 Put the ingredients into the jug.
31 Don't fill past the 1500ml mark. If you do, the contents may force the lid off when you start
the motor.
32 Replace the lid, and turn it to bring the d on the lid over the L on the jug, to lock it in place.
33 To add ingredients while the motor is running:
a) lift the pusher out of the tube
b) add the ingredients via the tube
c) replace the pusher
O WITH THE DISC
34 To fit the slicer or grater to the disc:
a) insert the tab into the centre of the disc
b) lower the slicer/grater into the disc
c) secure the latch over the edge of the disc
35 Lower the disc over the top of the spindle.
36 Replace the lid, and turn it to bring the d on the lid over the L on the jug, to lock it in place.
37 Remove the pusher, and drop the ingredients down the tube.
38 Replace the pusher, and use it to push the ingredients gently down the tube.
39 Don't use fingers or cutlery to push food down the tube – only the pusher.
40 The blade(s) on top of the disc will slice or grate the food into the jug.
41 Don't let the jug get more than about half full – stop and empty it.
42 To remove the slicer or grater from the disc, ease the latch away from the side of the disc, and
lift the slicer/grater off.
C CARE AND MAINTENANCE
43 Switch the appliance off (0) and unplug it.
44 Wipe the outside of the motor unit with a clean damp cloth.
45 Wash the removable parts in warm soapy water, rinse well, drain, and air dry.
` You may wash these parts in a dishwasher.
4