Faro MC01 S Mode D'emploi page 43

5.4 Remove the handpiece or contra-angle drill bit
WARNING
Hazard from rotating cutter or grinder.
Lacerations and damage to the chucking system.
 Do not touch the cutter or grinder when it is rotating!
 Remove the cutter/grinder from the contra-angle handpiece after treatment to avoid injury and infection when putting it away.
 After the milling or grinding tool has come to a stand still, turn the clamping ring as far as it will go and remove the milling or grinding tool.
 Turn the clamping ring back into its initial position.
5.5 Conversion for contra-angle handpiece drill bit
NOTE
Note
The handpiece must be converted to use contra-angle handpiece drill bits.
 Open the handpiece chuck.
 Insert the accompanying drill bit stop into the chuck.
 Press the contra-angle handpiece drill bit against the stop, close the clamping ring and make sure that the bit is firmly seated.
 Use the accompanying hook to remove the bit stop.
MC01 S - Instructions for use - EN
41