Spark Plug - Zipper Maschinen ZI-STE3000L Mode D'emploi

Fasten the oil plug cap and mount the cover again.
6.4 Air filter
1. Gain access to the air filter.
2. Wash the filter with warm water.
3. Let the filter become dry.
4. Let the air filter become saturated with engine oil.
5. Wring the filter out.
6. Clean the air filter box with a wet blanket.
7. Mount the air filter again.
ATTENTION: NEVER OPERATE THE MACHINE WITHOUT OR A NOT
MAINTAINED AIR FILTER!!!
6.5

Spark plug

Remove the spark plug cap
Screw out the spark plug.
Optical Control: When the electrodes are battered or the
isolation is damaged – change the spark plug!
Clean the spark plug.
Control the distance between the
two electrodes: 0,6 – 0,7 mm!
The gasket ring should be in a
good condition.
When the spark plug gets changed you must screw it in
with your hands. When you can't turn it any more you
have to use the spark plug wrench to fasten it with half an round.
Z.I.P.P.E.R Maschinen Austria www.Zipper-maschinen.at
0,6 -0,7
MM
GASKET RING
Seite 32