Fleischmann 39.0-2 Serie Instructions De Service page 13

17 Long 192
Addresses
(upper section)
18 Long 0
addresses
28 RailCom*** Bit 0=1 RailCom*** channel 1 (Broadcast) is swit-
Configuration
Bit 1=1 RailCom*** channel 2 (Data) is switched
29 Configuration Bit 0=0 Bit 0: With Bit 0 = 1 the direction of the
values
Bit 1=1 Bit 1: basic value 1 is valid for run ning the
Bit 2=1 Bit 2: With Bit 2 = 1 the recognition of
Bit 3=1 Bit 3: With Bit 3=1 RailCom*** is switched
Bit 4=0 Bit 4: With Bit 4 = 0 the motor control
Upper section of long addresses.
Effective on DCC with CV29 Bit 5 = 1.
When programming a long address with
the TWIN-CENTER or the PROFI-
BOSS, CV's 17, 18 and 29 are automati
cally set. While programming with the
multiMAUS and multiMAUS
PRO
CV's 17 and 18 are set.
Lower section of long addresses.
Effective on DCC with CV29 Bit 5 = 1.
ched on. Bit 0=0: switched off.
on. Bit 1=0: switched off.
vehicle will be reversed.
decoder with 28 or likewise 128
speed steps. If the decoder is to be run
using 14 steps, then Bit 1 = 0 should
be set. The desired steps can be set
using the equipment.
analog power is switched on. With
Bit 2 = 0 pure digital operation is valid.
For operation layouts with mixed multi-
train languages, i.e. with TWIN-CEN-
TER, or while using analog braking
tracks (see "Braking") pure DCC must
be switched on.
on. With Bit 3=0 it is switched off.
, only
60 Light dimming
66 Speed
adjustion,
forward
67 Modification of
to the regulation
94 characteristic
of the
control unit
95 Speed adjustion
backward
112 Configuration
values
(only Motorola*)
characteristic line will be calculated by
CV's 2, 5, 6. With Bit 4 = 1 the control
line set in CV's 67 to 94 will be used
(DCC operation only).
Bit 5=0 Bit 5: to utilise the long ad dres ses
128 to 9999, Bit 5 =1 should be set.
accor- The value of this CV sets the
ding maximum intensity of the front lights.
to the 0=off until 255=bright.
loco
0 Numerical values from 1 to 255 to alter
the graduation of the control line for
running forward. Numbers larger than
128 will increase the speed, numbers
lower than 128 decrease. With 0,
nothing more will happen.
A speed value between 0 and 255 can
be put into each of the 28 CV's from 67
to 94. In CV67 it's the lowest and CV94
it's the highest speed. The intermediate
settings give the control characteristic
line. It determines how the vehicle
speed alters in relation to the controller
settings. This control line is active with
CV29, Bit 4 = 1.
0 Same as CV66, but for backward
running.
Bit 3=0 Bit 3=0: normal ( 4 functions for every
address).
Bit 3=1: the following address will be
used for 4 additional functions. There
are 8 functions availabe now for this
loco.
11