Fleischmann 39.0-2 Serie Instructions De Service page 12

the control unit 6021 should be in the ON position (see also chapter 6).
With the old Motorola* format, as well as the Delta** system, it can be run, but
no sounds can be called up.
4. TROUBLESHOOTING
1. The loco will run forwards/backwards as normal but the lights are off:
This is correct, dictated by the system for DC operation.
For DCC operation, the Sound decoder has been pre-set at the factory for
28 speed steps. Probably the running of the loco has been set to 14 steps. Simply
re-set the equipment to 28 steps, or re-program the Sound decoder to
14 steps (see CV29 in chapter 5).
2. The loco sound is not clear:
Run the loco in pure DCC- or Motorola*-operation.
3. The loco does not respond to Motorola* commands:
If the decoder is set to handle the long DCC-address, then you must change the
setting to use the short address (CV29, bit5 = 0).
5. LIST OF THE IMPORTANT CV's
CV Name Basic Description
Value
1 Loco address accor- Defines the digital Address for DCC (3)
ding
to the dress of the loco decoder
loco
2 Start-up voltage accor- This CV sets the motor voltage of speed
ding
to the the motor characteristic table
loco
3 Acceleration accor- Inertia values when accelerating
inertia ding
to the
loco
10
and Motorola* (78/72/24/60) 1-Byte ad-
level 1, if not set by CV 29 Bit 4 as in
4 Braking inertia accor- Inertia values when braking
ding
to the
loco
5 Maximum accor-
voltage ding
to the
loco
6 Middle accor- Running voltage setting for the middle
voltage ding
to the By using this CV it is possible to set a
loco
8 Manufacturer 145
Identification
13 Analogmode 01
F1 through F8
14 Analogmode 0
F9 through F12,
and frontlight
This CV sets the running voltage of the
highest speed level. Possible maximum
is 252. See also CV2.
area speed steps.
non-linear control characteristic.
NMRA identification number for producer
Zimo. By programming this CV with
the value 8 will re-set to the factory
setting. Warning: the control unit
may indicate an error.
(00 - no function in analogmode)
01 - function F1 02 - function F2
04 - function F3 08 - function F4
16 - function F5 32 - function F6
64 - function F7 128- function F8
Attention:
While activating multiple functions
(value adding) for the CV's in analogmo
de, the execution is simultaneous.
01 - frontlight ahead
02 - frontlight rear
04 - function F9 08 - function F10
16 - function F11 32 - function F12
64 - analogmode without delay
possible (CV3, CV4)
128- analogmode controlled