CombiSteel 7464.0055 Mode D'emploi page 9

Leveling the deep freezer
The floor where the deep freezer is placed should be level and the deep freezer should be leveled in
order to operate properly.
In order to level the deep freezer, unscrew the stand screws of the deep freezer by laying the deep freezer
forward and backward by holding from its front and rear sides. Leave the deep freezer on the floor and check
whether it is level or not by using a water gauge. If, it is inclined to anyway, adjust by means of the stand screws.
Installing the racks
Only valid for VF500 model deep freezers!
In your deep freezer, there are totally 6 racks as 5 of them as standard and 1 as base rack and 20 rack supports.
In order to install the racks in their places, install the rack supports/holders in accordance with the sizes of the
products to be put on the rack by using the numbers on the rack bars. You can seat the rack supports/holders by
holding them from both ends by pliers in order to install them easily.
Firstly, place the base rack on the base of the deep freezer. Then, seat the first rack to be placed on the base rack
on the lugs of the rack supports/holders by slightly bending it. Then install the other standard racks by applying
the same method.
Do not ever load anything on the base of your deep freezer. Load your thing on the base rack of it.
www.combisteel.com
9