Installation; Positioning; Installation Procedure - CombiSteel 7464.0055 Mode D'emploi

INSTALLATION

The installation, positioning, operation, maintenance and cleaning of your deep freezer should be performed in
accordance with the operating manual. Please, do not perform any other practice other than the ones described
in this operating manual. If, your deep freezer is damaged or fails due to a practice mentioned above, it will be
out of the guarantee scope.

Positioning


It is very important to ensure the following environmental conditions for problem free and efficient
operation of your deep freezer.

The ambient where your deep freezer will be placed, should be in accordance with the conditions of
the class mentioned on the type label.

Please, do not forget that the UV rays of the Sun will affect the food in the deep freezers with glass
doors. Position your deep freezer (even if it is empty) at an appropriate location where it cannot be
subjected to direct sunlight.

This product is not suitable for using in places with fire, explosion or radiation risk.

Unless, otherwise explicitly mentioned, do not place your deep freezer in open environments where
your deep freezer can penetrate water.

While you are placing your deep freezer, maintain minimum 10 cm spaces from the top, rear and sides
of your deep freezer in order to ensure air circulation. If, you will place another deep freezer or a
refrigerator next to it, please be careful that the space between both units is minimum 30 cm.

Do not ever cover or close the ventilation holes (the plastic front grid, rear grid) of your deep freezer.

Installation procedure

Remove all packing materials and dismount the wooden pallet before placing your deep freezer.
Disassembling the wooden pallet
Weight of your deep freezer should be taken into consideration while removing the wooden pallet.
The deep freezer is delivered to you on the wooden pallet by fixing with 4 cable ties. Please, read the following
instructions, before placing your deep freezer in its place. The cable ties fixing the deep freezer with the wooden
pallet at front and rear sides are removed by cutting with a cutter. The pallet is removed from the bottom of the
deep freezer by laying down the deep freezer from its rear side. The deep freezer is placed on the floor. If, the
floor is not level, the product is leveled.
www.combisteel.com
8