Cardin Elettronica PRG401 Mode D'emploi page 9

Container installation procedure
3A
• Remove the screws "B" and carefully extract the
P.C.B. card "C" from the container remember-
ing to store it somewhere safe from dust and
possible damage.
3B
• Using the container as a template mark the
four points at which the fastening holes are to
be drilled;
• Fasten the container using four screws and raw
plugs "G" and insert the screw covering plugs
"H".
• Insert the pipe fittings "D" (fig. 3A) and check
that they are fastened correctly.
3C
• Re-insert the electronic card into the container
and fasten down using the screws "B" (fig.
3A)
• Insert the rigid electrical connection pipes "I"
into the cable tubes. The 230V power cables
should be passed through pipes 1 and 2 (see
figure) so as to separate them from the low
voltage wires which should be passed through
pipes 3 and 4.
• Carry out the electrical connection following
the attached wiring diagram (see fig. 2).
All rights reserved. Unauthorised copying or use of the information contained in this document is punishab
Description:
Drawing number : DM043
PRG40/LSO
Product Code : PRG40
Draft : P.J.Heath Date : 06-07-96
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable b
Drawing number :
DM035
Product Code : LPRG
Draft : P.J.Heath Date : 27-04-98
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
9
A
A
D
C
E
F
INSTALLAZIONE CENTRALINA CE (fig.)
G
M
1 3 0 M
Description :
Installazione contenitore PRG
3
4
3
B
B
H
I
1
2