Power Supply; Connecting The Video Cable - Abus HDCC50000 Manuel Utilisateur

5.2. Power supply

IMPORTANT!
Before starting installation, ensure that the power supply voltage and the rated voltage
of the camera are identical.
The cameras require a 12 V DC or 24 V AC
power supply. The polarity of the DC voltage
supply does not need to be observed!

5.3. Connecting the video cable

In order to transmit the HD-TVI video signal from the camera to a recorder, an RG59 or RG6 type coaxial
cable with BNC connector (male) must be connected to the connection labelled 'TVI'. The cable length to
the next device must not exceed 500 m (RG6) or 300 m (RG59).
An RG59 or RG6 type coaxial cable can be connected to the analogue video output (labelled 'CVBS').
The cable length to the next device must not exceed 100 m.
To ensure optimum quality of the HD-TVI signal transmission, it is important that the cable is
neither kinked nor crushed at any point, and that its radius is adequate (min. bending radius
6 cm).
Damage to the cable or porosity as a result of ageing can have a negative impact on the
quality of the signal or image (e.g. shadowing around the edges).
27
English