Abus HDCC50000 Manuel Utilisateur page 30

Function Description
SHUTTER Exposure time setting
AUTO:
1/50:
AGC Setting for max. gain value (upper limit) used by the camera (0~15). The camera
selects the gain value automatically.
SENSITIVITY Continuous exposure setting. Longer exposure times for each image make the
resulting image lighter. However, the longer the exposure time, the lower the
frame rate.
OFF:
AUTO (2x~30x):
BRIGHTNESS Basic image brightness setting (1~100)
D-WDR Software enhancement of the contrast ratio in the image. Dark areas are
brightened, whilst trying to not increase the brightness of existing light areas.
OFF:
ON:
DEMIST This function enhances the image quality in the event of a misty camera view.
OFF:
ON:
POS/SIZE:
DEGR.
RETURN Return to previous menu screen
BACKLIGHT
Function Description
OFF Deactivate all backlight or contrast treatment
WDR Wide dynamic range function. Contrast treatment of the video image through
double exposure (short and long exposure) of the image.
GAIN (LOW/MEDIUM/HIGH):
WDR BRIGHT (0~60):
WDR OFFSET (0~60):
BLC Backlight compensation. The function displays light areas of the video image
darker, whilst maintaining the brightness of dark areas.
GAIN (LOW/MEDIUM/HIGH):
AREA (POSITION/SIZE):
STANDARD:
HSBLC This function marks areas above a certain brightness level black. This function
may be used, for example, solely at night for oncoming vehicle headlights. In
this case, the headlights will be marked black. The registration plates next to the
Automatic adjustment of the exposure time to the
environmental conditions.
Fixed exposure time
Continuous exposure deactivated
Continuous exposure activated, with value for upper limit
Function deactivated
Function activated
Function deactivated
Function activated
Reference area size and position setting
Intensity levels for the function
Move basic setting on a brightness scale
Change basic gain factor
Intensity of the function
Intensity of the function
Setting of the reference area for the
calculation. Press ENTER to change the
position with the control buttons. Press ENTER
again to change the size with the control
buttons.
Press ENTER to reset all parameters of the
BLC function to the factory settings.
30
English