Lubrication - Kobalt VT6362 Mode D'emploi

ASSEMBLY INSTRUCTIONS

LUBRICATION

CAUTION
Inspect Before Use. Check for proper oil level
before operating!
Remove oil fi ll plug on pump. Check oil level;
some models are shipped with oil in the pump.
See specification label on compressor pump
for the proper oil capacity and oil type. Add oil if
needed. Place oil fill plug back on pump.
OIL INFORMATION
Kobalt Air Compressor Oil
Kobalt Synthetic Blend Oil
®
Mobil 1 synthetic 10W30
Oil Capacity
Do not use regular automotive oil. Additives in
regular motor oil can cause valve deposits and
reduce pump life.
For maximum pump life, drain and replace oil
after the first hour of run time.
This pump has an oil sight glass as shown
in Figure 1. Oil level can be monitored and
maintained as shown in Figure 2.
PIPING
WARNING
Risk of Personal Injury. Never use plastic
(PVC) pipe for compressed air. Serious injury
or death could result.
Any tube, pipe, or hose used must have a pressure rating higher then 175 PSI. Minimum
recommended pipe size is 3/4 in. Larger diameter pipe is always better.
SKU 221008
SKU 221009
8.5 ounces
15
1
Breather
Oil Drain
2
Sight Glass
Oil Fill
Plug
Sight
Plug Glass
Full
Low
kobalttools.com