Installation Instructions - Etherma ET-SOLID Instructions De Montage Et D'utilisation

Installation instructions

• The infrared radiator may only be installed and operated horizontally!
• The heater must only be installed using suitable fastenings (e.g. use M6x60
bolts with steel anchors in a stone or concrete substrate) on a firm, load-bea-
ring, standard, flame-resistant or non-combustible substrate.
• If heater and socket are not installed on the same surface, it must be ensured
that the field of radiation cannot be directed towards the socket. Failing this,
it must be ensured that the socket cannot heat up to more than 70°C during
heater operation.
• The safety distances given in Appendix 1 must be observed.
• The area in which the heat acts can be estimated from the radiation diagram
(Appendix 2). The diagram shows the sizes of the irradiated areas at various
distances from the radiant heater and in each case the maximum radiation
intensity.
• Installation height: at least 1.80 m above the ground
• Mount the T-bracket with 2 screws on the mounting surface, observing the
safety clearances and safety instructions (see Appendix 1)
• Centre the clamping slide on the heater and secure by tightening the clamping
screws.
• Position the heater on the T wall bracket using the clamping slide. Insert the
M6 screws, complete with 6.4 mm serrated washer, on the sides through the
clamping slide into the T wall bracket, then manually tighten.
• Position the heater so that it radiates in the desired direction and then tighten
the two M6 screws using a 5 mm Allen key.
15
03/2020