(C) Distance Adjustment - Champion RANGE AND TARGET WHEELYBIRD 2.0 Mode D'emploi

(C) Distance Adjustment

WARNING: BEFORE MAKING ANY ADJUSTMENTS, MAKE SURE THE THROWING
ARM IS IN THE UNCOCKED POSITION, THE ON/OFF/SAFE RELEASE SWITCH IS
IN THE "OFF" POSITION, AND THE BATTERY IS DISCONNECTED FROM THE
TRAP. THIS TRAP IS CAPABLE OF THROWING TARGETS A DISTANCE OF UP TO
75 YARDS. USE ONLY IN AREAS WHERE THERE IS NO RISK OF INJURY TO
ANOTHER PERSON OR CAUSING OTHER DAMAGE.
WARNING: DO NOT MANUALLY FORCE THE THROWING ARM THROUGH THE
UNCOCKED POSITION AS THE MAIN SPRING WILL TAKE OVER AND FIRE THE
TRAP, POTENTIALLY CAUSING SERIOUS INJURY OR DEATH.
Adjustment to throwing distance is made by adjusting the mainspring tension.
1. With Handnut (S4) fully tightened on Mainspring Bolt (S2), the mainspring is under
standard tension. The trap will throw targets a distance which should be suitable for
most users.
2. If reduced throwing distance is desired, mainspring tension can be adjusted to reduce
the throwing distance. Loosen Handnut (S4) up to a 1/2" on the Mainspring Bolt (S2). DO
NOT EXCEED THIS AMOUNT-DAMAGE OR PREMATURE WEAR COULD RESULT.
3. After adjusting the spring to the desired tension, there should be a minimum of 2-3/4"
of the Mainspring Bolt (S2) exposed from the main thrower chassis.
4. Check Handnut (S4) every 200 throws to ensure correct setting is maintained.
S4
Bolt Tip to Chassis
S3
2 3/4" to 3 1/4"
S2
19