Accessories - Roco RouteControl 10772 Mode D'emploi

When reading a track route move through the
positions only with the cursor keys and the "ok" key
after call-up of the track route and the editor. Press-
ing the "ok" key twice returns to layout operation
after reaching the last position.
A track route can be erased completely as
described above if after it is called up and the editor
is activated with the cursor "s" the last position
"End" is reached and subsequently the key "esc" is
GB
pressed.
If at the indication "dEL" (question: Erase?) the "ok"
key is used to acknowledge, the complete track route
is erased.
Special considerations for use of
two RouteControl units
If two RouteControl units are used in the Lok-
maus 2 system you have to address the turnouts in
®
the system with the same 128/256 separate ad-
dresses. Different inputs are psooible for the track
14
14
routes of both RouteControls so that their number
can be increased to 2x32 = 64 track routes.
The call-up of one track route from each Rou-
teControl is possible at any time. The "dispatcher"
himself has to watch out that the two called up track
routes will not cause any collisions!
The position indication of single turnouts is
mutually exchanged with a maximum time delay
of 2 seconds. This also takes place if i.e. a turnout
008 (called up on the display of RouteControl no.1
in single-turnout position) if a track route is set on
RouteControl no.2 which includes the turnout 008.

Accessories

Separately available are both cable sets which are
furnished with the keyboard:
DataBUS cable:
"Maus-Bus" cable:
also available:
art.no. 10756
art.no. 109891
DataBUS spiral cable 10754