Connecting Intellichlor Communication Cable (Rs485) - Pentair INTELLICHLOR IC15 Installation Et Guide D'utilisation

WARNING - Switch OFF main system power to the Load Center before making any connections.

Connecting IntelliChlor Communication Cable (RS485):

1. Unlatch the load center/power center enclosure door spring latch, and open the door.
2. EasyTouch/IntelliTouch: Loosen the two (2) retaining screws from the control panel.
(a) Lower down the control panel on its hinges to access the motherboard located behind the control
panel.
(b) Route the four conductor cable up through the low voltage raceway in the load center to the
motherboard.
Note: For SunTouch system see page 28 for details.
3. Strip back the cable conductors ¼ in. Insert the wires into the connector screw terminals (provided
in the kit). Secure the wires with the screws. Make sure to match the color coding of the wires;
Red = +15, Yellow = +DT, Green = -DT, and GND = Black.
4. Insert the connector screw terminal onto the COM Port pins on the circuit board: (EasyTouch
J20, IntelliTouch J7/8).
7. When the connection is completed: EasyTouch/IntelliTouch: Close the control panel and secure it
with the two (2) retaining screws.
8. Close the load center front door. Fasten the spring latch.
COM PORT
(J20)
Indoor Control Panel
IntelliChlor
IntelliFlo
RF Transceiver
EasyTouch Circuit Board
Note: EasyTouch/IntelliTouch Automation Load Center
For information about connecting IntelliChlor to the EasyTouch/IntelliTouch load
center with built-in SCG power supply, please refer to the EasyTouch
IntelliTouch
Chlorine Generator) Load Center Installation Guide (P/N 521139)
®
Pool and Spa Control System (with optional IntelliChlor
IntelliChlor Electronic Chlorine Generator Installation and User's Guide
COM ports
BLK
(Connector J7 or J8)
GRN
YEL
RED
IntelliTouch Personality Circuit Board
®
and
®
Salt
27
Personality board
9.