Sony MDS-JB920 Mode D'emploi page 38

Controlling a Separately Available Sony CD Changer
To stop recording
Press p on the deck.
The CD changer and MD deck both stop.
Note
If a CD is not loaded to the selected disc number, "No Disc"
appears in the display.
z
The deck copies CD text information (CD text and
disc memos) as it is to the MD (Disc Memo Copy
Function)
When the current CD is labeled, the CD disc and track
titles are recorded as the MD titles. However, the disc
title is not copied if the MD is already labeled.
z
When "No Connect" appears in the display
Check the control A1 cable connection and make sure
the CD changer mode selector is set to CD1. After
checking, turn the MD deck and CD changer off and
then on again, then reset the Mega CD Control mode.
z
You can use the REC IT Function in Mega CD Control
mode
You can record a track on an MD while listening to a
CD.
For details, see "Recording the Current CD Track" on
page 21.
Notes
• The MD deck stops automatically if the remaining time on
the MD runs out during the recording.
• The Disc Memo Copy Function may not operate for
extremely short CD tracks.
• Text information may not be copied for some CDs.
• If the control A1 cable becomes disconnected during
recording, turn the deck and CD changer off and on, reset
the Mega CD Control mode, and then start recording over
from the beginning.
While "TOC Writing" is flashing
Do not move the deck or pull out the AC power cord to
ensure the complete recording. The deck is currently
updating the MD Table of Contents (TOC).
38 EN