Disposal Of The Unit; Helpful Advice - Arneg LUCERNA 2 105 H150 Manuel D'installation Et D'utilisation

Lucerna 2
English
and water.
- Rinse with clean water and dry with a soft cloth.
- DO NOT use abrasive products or solvents that can affect the surfaces of the unit.
- DO NOT spray water or detergents onto the electrical parts of the unit.
- DO NOT use alcohol to clean parts in Plexiglas.
Cleaning of internal parts (Monthly)
Cleaning the unit's internal parts is done to destroy pathogenic micro-organisms so as to ensure
protection of merchandise.
Before beginning to clean the inside of the unit, it is necessary to:
- Completely remove all merchandise inside;
- Disconnect the unit's power supply using the main switch;
- Remove any removable parts, including display plates, grills, etc. These should be washed with
warm water and detergent that contains disinfectant, and then dried carefully;
- Carefully clean the tank, drip, and water discharge protection grill, eliminating all foreign bodies that
may have fallen into the suction grill, lifting the fan plate if necessary.
- If anomalous ice has formed, contact a Qualified Refrigeration Technician for assistance.
Complete the cleaning operation by reattaching the dry removable elements and by restoring the
electrical supply. Once internal operating temperature has been reached, the unit can be loaded with
the products to be displayed.
Note:Avoid wetting fans, lights, electric cables, and all electrical devices in general during clea-
ning operations.
ATTENTION!: If using a water jet cleaner to clean the interior, use a LOW PRESSURE
system. Take special care NOT direct the jet onto painted or plasticised surfaces and
keep a minimum distance of 30 cm from the surface to be cleaned (Fig. 4).

18.Disposal of the unit

The unit must be disposed of in accordance with your country's waste management legislation and in
respect of our environment.
This product is considered by current legislation as hazardous waste. It must therefore be collected
separately and cannot be treated as household waste nor sent to a landfill. Before disposing of the unit,
the coolant must be collected and the lubricant oil removed. The user is responsible for delivering the
product for disposal to the collection centre specified by the local authorities or manufacturer for the
recovery and recycling of materials. This product consists of 75% recyclable materials. Materials used
in construction:
- Stainless steel 18/10 (AISI 304): various trimmings
- Steel sheet metal and tubes:
- Copper, aluminum:
- Galvanized sheet metal
- Polyurethane foam (R134a):
- Tempered glass:
- PVC:
- Wood:
- ABS
Note:All these operations including transportation and waste management must be performed
exclusively by specialized and authorized personnel.

19.Helpful advice

It is recommended that the Installation and Use Manual be read carefully, so that the operator, in the
case of malfunction, is able to provide precise information to Technical Assistanceby telephone.
Before carrying out any maintenance operation on a refrigeration unit, make sure that the power supply
has been turned off.
In the case in which the customer notes type of anomaly in unit performance, before worrying and con-
tacting Customer Assistance, it is very important that the following items are checked:
- Carry out all work operations with extreme attention (loading, unloading, cleaning, customer
sales, maintenance, etc.) and when performing various operations, always use the maximum
care and the necessary protective devices.
20
lower frame, shelves, and shelf support risers
refrigeration circuit, electricalsystem, various trimmings
internal sheet metal, lower panels, painted panels
thermal insulation
edging glass
bumper edges, baseboard closing edge
foamed tank side frames
external head roof
05060090 00 12/02/2010