VWR 444-0268 Manuel D'instructions page 9

M S S -U
ICROPLATE HAKER ET
The Microplate Shaker is designed to hold two (2) or four (4) microplates, or two (2) Micro-Tube Racks.
1. Place two (2) microplates or deep well blocks diagonally on the tray, or place four (4) microplates or deep well blocks on the tray. The plates/blocks
do not have to be filled.
2. Place the corner of the plate/block under the spring located at each corner of the tray.
3. Slide plate/block into place. You are ready to use.
2.
M S T
ICROPLATE HAKER RAY
(2) microplates
NOTE: The tray on the Microplate Shaker is not designed to hold flask clamps.
P
3.
C
ONFIGURATIONS
(4) microplates
4.
(2) Micro-Tube Racks
8