Accessories - VWR 444-0268 Manuel D'instructions

A
CCESSORIES
TEST TUBE RACKS
D
ESCRIPTION
10 to 13mm Test Tube Rack
14 to 16mm Test Tube Rack
18 to 20mm Test Tube Rack
22 to 25mm Test Tube Rack
15mL Centrifuge Tube Rack
50mL Centrifuge Tube Rack
1.5 to 2mL Micro-Tube Rack
Installation of Test Tube Racks - Mini Shaker
1. Unit should be in standby mode.
2. Remove non-skid rubber mat.
3. Align the clip on the rack to the right side of the tray.
4. Line up the holes in the test tube rack to the holes in the tray. Using the
screws provided, hand tighten into place using a flathead screwdriver. DO
NOT over tighten.
Installation of 1.5 to 2mL Micro-Tube Rack - Microplate Shaker
1. Unit should be in standby mode.
2. Align the Micro-Tube Rack side-to-side on the tray.
3. Press the Micro-Tube Rack in place, you will hear the Micro-Tube Rack clip
into position. No mounting screws are required.
13
T P
UBE LATFORM
C C
APACITY APACITY
63 2 444-0278
48 2 444-0279
35 2 444-0280
24 2 444-0281
42 2 444-0283
12 2 444-0284
70 2 444-0282
FLASK CLAMPS
D
ESCRIPTION
C . N . 10mL Erlenmeyer Flask Clamp
AT O
25mL Erlenmeyer Flask Clamp
50mL Erlenmeyer Flask Clamp
125mL Erlenmeyer Flask Clamp
250mL Erlenmeyer Flask Clamp
500mL Erlenmeyer Flask Clamp
500mL Media Bottle Clamp
Installation of Flask Clamps - Mini Shaker
1. Unit should be in standby mode.
2. Remove non-skid rubber mat.
3. Line up the hole(s) in the flask clamp to the hole(s) in the tray. Using the
screw(s) provided, hand tighten into place using a flathead screwdriver.
DO NOT over tighten.
4. Insert flask/media bottle into clamp and wrap the spring around the neck
of the clamp to hold secure.
Not for use with the Microplate Shaker.
P C C . N
LATFORM APACITY AT
35 444-7040
20 444-7041
15 444-7042
12 444-7043
6 444-7044
4 444-7045
3 444-7035
.
O