Safety Notes; General Notes; Functions - Trix Minitrix BR V 200 11129 Mode D'emploi

Locomotive
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Safety Notes

• This locomotive is to be used only with an operating system designed for it.
• Use only switched mode power supply units and transformers that are designed for your local power
system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Do not expose the model to direct sunlight, extreme changes in temperature, or high humidity.

3. General Notes

• The operating instructions and the packaging are a component part of the product and must therefore
be kept as well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare parts.
• http://www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where parts neither manufactured nor approved by
Trix have been installed in Trix products or where Trix products have been converted in such a way that the non-Trix
parts or the conversion were causal to the defects and / or damage arising. The burden of presenting evidence and the
burden of proof thereof, that the installation of non-Trix parts or the conversion in or of Trix products was not causal
to the defects and / or damage arising, is borne by the person and/or company responsible for the installation and / or
conversion, or by the customer.

4. Functions

• Built-in electronic circuit for operation with an conventional DC power pack, Trix Selectrix or
NMRA DCC digital.
• The mode of operation is automaticaly recognized.
• Addresses that can be set: 1 - 127
• Address set at the factory: 3
• Triple headlights only at the front in analog operation, in digital operation triple headlights that change
over with the direction of travel.
• ABV — Adjustable acceleration/braking delay.
Several of the locomotive's characteristics can be adapted to your own ideas by programming the Con-
figuration Variables (CV). The programming for the CVs described below can be found in the instructions
for your controller.
CV Discription
1
Adress
3
Acceleration delay
4
Braking delay
5
Maximum speed
Factory-
Value
Set
1 - 127
3
0 - 255
10
0 - 255
5
1 - 7
6
5

Publicité

Table des Matières
loading

Table des Matières