MASCOT 205240 Mode D'emploi page 8

EN EN
Charging method B
Diagram: A
STEP 1 – BOOST CHARGE
To start a charge cycle, connect the charger to the mains.
INDICATOR: ORANGE
The charger is in constant current mode, charging with the maximum current indicated on
the charger, the LED-indication on the charger is ORANGE. This step allows rapid charging
of your battery until the battery voltage has increased to a certain set level.
STEP 2 – TOP-UP CHARGE
When the battery voltage has increased to a certain set level the charger enters constant
voltage mode, charging with a decreasing current until the current is below the chargers
charge termination level (indicated on the charger). The LED-indication on the charger is
Charge Current
ORANGE.
When the battery has reached typically 90 - 95% of its full capacity the charge current has
dropped below a set level and the LED-indication on the charger changes to YELLOW to
indicate that the battery is almost fully charged and may be ready for use. The constant
voltage charge continues and the battery reaches its full capacity at the end of this step.
STEP 3 - FLOAT CHARGE
The LED-indication on the charger is GREEN and the battery is fully charged.
Step 1
Boost Charge
The charge voltage is at float level and the charger may remain connected to the battery.
The charger will return to Step 1 if the battery is used. A load larger than the cut-off current
will initiate a new charge cycle.
Diagram: B
INDICATOR: ORANGE
Charge Current
Step 1
Boost Charge
Charge Voltage
Cut-Off Current
Top-up Charge
Lead acid diagrammer
Charge Voltage
Cut-Off Current
Top-up Charge
Step 2
INDICATOR:
YELLOW
Step 2
8
INDICATOR: GREEN
Charge Voltage
Step 3
Float Charge
INDICATOR: GREEN
Charge Voltage
Step 3
Float Charge
Orange
Orange
Orange
Orange
Orange
Green
Orange
Green
Orange
Yellow
Green
Yellow
Yellow
Orange
Yellow
Yellow
Yellow
Green
Yellow
Yellow
Red
Orang
Yello
Gree