MASCOT 205240 Mode D'emploi page 3

• The intended use for this product is to charge
a battery or a battery powered electrical
accessory (NiCd/NiMH, Lead-Acid, Lithium-Ion
or LiFePO batteries) or to be used as a Power
4
Supply to power an electrical accessory. Please
see the marking on the product you have to
verify the type of product you have and read
the applicable instructions and technical
specifications included with this manual.
• This product may be used by unskilled
operators, under the condition that these
instructions are followed.
• Unskilled operators may contact the supplier
or manufacturer for assistance, if needed, in
setting up, using or maintaining this product
and to report unexpected operation or events.
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Do not
allow small children to handle this product while
unattended as cables may represent a risk for
strangulation and small parts may represent a
risk for inhalation or swallowing.
• Do not allow animals to come into contact
with this product. Some animals are known to
cause damage to cables etc which may be a
potential for risk of electric shock and excessive
temperatures. Also, cables and small parts may
represent a strangulation risk for the animal.
• If the product is equipped with a mains cord,
please check that the cord is not damaged. If
the cord is damaged, the product must not be
used until the cord is replaced. Replacement
should be carried out by qualified personnel.
• The mains socket outlet used should always
Cautions to observe prior to use
be easily accessible to facilitate immediate
removal of the products mains supply should
an operational error occur during use. If the
product has a detachable mains cord the
appliance coupler may be used as a disconnect
device.
• The product is "switched on" by inserting the
mains plug into the mains socket and "switched
off" by disconnecting the mains plug from the
mains socket.
• The product may be connected to an IT type
mains supply.
• For use in U.S.A.:
- Be sure to use 125V 15A receptacle
configuration before plugging in.
- Use a UL817-standard compliant mains cord
(plug type NEMA 1-15, cord type SJT or SVT).
• For use outside U.S.A:
Use a mains cord compliant with the country
specific requirements.
• The time from powering this product until its full
function starts may exceed 15 seconds.
• Should an operational error or unexpected
change in the performance occur during
use; disconnect the product from the mains
immediately by disconnecting the mains plug
from the mains socket and contact the supplier
or manufacturer (see contact details on the
front of this document).
• When not in use please think about
disconnecting the product from the mains.
This will reduce the risk of hazards, reduce
the products environmental impact and save
electricity costs.
• To avoid overheating make sure there is
sufficient room for the circulation of air around
the product when in use. Do not cover it up.
3
EN