Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to connect exchangeable DC-output plugs
3
3
How to connect exchangeable AC-plugs
The following exchangeable AC plugs are available:
"EURO"
250V 2.5A (EN50075/IEC83 C5 II)
"US"
125V 2.5A (NEMA 1-15 / CSA-C22.2 No.42)
"UK"
250V 13A (BS 1363)
"AUS"
250V 10A (AS/NZS 3112)
Mains Cord Set is available on request if you wish your product to be "DeskTop"
Mounting and use for bracket Mascot, part no. 205800
Wall mount: Fix the bracket to the wall using screws suitable for the wall material and:
head diameter: 8 - 9.5 mm, head height: max. 3 mm,
thread diameter: 4 - 5.5 mm, thread length: min. 16 mm.
Use one screw for each of the oval openings in the bracket, total four screws.
Place the Power Supply / Charger centred on the bracket so that the slot in the bottom housing is in line
with the tabs on the bracket.
Push down on the handle marked "Push" while pushing the product against the wall. Release and the
product locks to the wall mount.
Release the product from the wall mount by pushing down on the handle marked "Push" while pulling
the product from the wall.
If not fixed to a wall the bracket may be used as a handle, following the same procedure.
12
1 2
1. To connect for desired polarity, both plug
ends are clearly marked.
2. When connected, the female plug is also
marked on each side to identify plug
polarity.
3. Shows the center polarity of the plug.
11
EN
Publicité
Table des Matières
