Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USE ORIGINAL EQUIPMENT REPLACE MENT PARTS. Use of third-party or other alternate components will void warranty and
may cause unsafe operating conditions.
Fire or explosion hazard!
- Never service heater while it is plugged in or while hot!
FUEL TANK
FLUSH EVERY 200 HOURS OF OPERATION OR AS NEEDED
(See Longterm Storage, page 11).
AIR INTAKE FILTER
Screw Upper Shell
Air Intake Filter
Figure 10 - Air Filter Access
WASH AND DRY WITH SOAP AND WATER EVERY 500 HOURS
OF OPERATION, OR AS NEEDED.
- Remove screws along each side of heater using medium
Phillips screwdriver.
- Lift off upper shell.
- Remove fan guard.
- Wash or replace air intake filter.
- Reinstall fan guard and upper shell.
AIR OUTPUT FILTER, LINT FILTER
Air Output Filter
End Filter Cover
Lint Filter
Air Intake Filter
Air Pressure Gauge
Figure 11 - Filter Assembly
WARNING
Fan Guard
Screw
REPLACE EVERY 500 HOURS OF OPERATION OR ONCE A
YEAR
- Remove upper shell and fan guard (See Air Intake Filter
Figure 10).
- Turn air pressure gauge counter-clockwise and remove.
- Remove end filter cover screws using medium Phillips
screwdriver.
- Remove end filter cover.
- Replace air output and lint filter.
- Reinstall end filter cover and air pressure gauge.
- Reinstall fan guard and upper shell.
PUMP SERVICING
•PUMP ROTOR
Pump Body
Rotor Insert
Rotor
Figure 12 - Rotor Pump Assembly
REPLACE IF CHIPPED, CRACKED OR AS NEEDED
- Remove upper shell and fan guard (See Air Intake
Filter Figure 10).
- Turn air pressure gauge counter-clockwise and
remove.
- Remove end filter cover screws using medium Phillips
screwdriver (see air output filter, lint filter Figure 11).
- Remove air output filter and lint filter.
- Remove end pump cover screws using a 5/16"
(8mm) nut driver/socket.
- Replace rotor, all 4 vanes and plastic rotor insert. All
of these components must be replaced at the same
time.
MAINTENANCE
Screw
Vane
End Pump Cover
Screw
12
Publicité
Table des Matières
Dépannage
