Electrolux 136936003 Instructions D'installation page 10

10 Installation Instructions
IMPORTANT
If moving dryer from a 4-wire system and
installing it now in a 3-wire system, move the
internal ground wire from the center terminal
back to the GREEN screw under the termi-
nal block.
Electrical Connection
(Non-Canada)-4 Wire Cord
30 AMP
NEMA 14-30
NOTE
Two cords shown above with different
terminal types.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before
servicing could result in personal injury or
even death.
1. Turn off power supply to outlet.
2. Remove the three screws securing the
terminal block access cover in the upper
corner on the back of the dryer.
NOTE
Terminal screws were shipped from the factory
temporarily attached inside the access cover.
4-wire receptacle
(NEMA type 14-30R)
Neutral
Ground
(WHITE
(GREEN
wire)
wire)
Terminal cover
3. Disconnect the internal (WHITE) dryer
harness wire from the (GREEN) ground
screw next to the terminal block.
4. Using an UNPLUGGED, UL-approved,
30 amp. power cord, NEMA 14-30 type
ST or SRDT, attach the ground (GREEN)
power cord wire to the cabinet with the
ground (GREEN) screw. Tighten the screw
securely.
GREEN
ground wire
Access
cover screw
DO NOT
REMOVE
THIS SCREW
Access cover
screw
Access cover
screw
internal ground
(GREEN screw)
Internal (WHITE)
dryer harness
wire
GREEN
ground
screw