Electrolux 136936003 Instructions D'installation page 9

Electrical Connection
(Non-Canada) - 3 wire
Cord
3-wire receptacle
(NEMA type 10-30R)
30 AMP
NEMA 10-30
NOTE
Two cords shown above with different
terminal types.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before
servicing could result in personal injury or
even death.
1. Turn off power supply to outlet.
2. Remove the three screws securing the
terminal block access cover in the upper
corner on the back of the dryer.
NOTE
Terminal screws were shipped from the factory
temporarily attached inside the access cover.
Terminal cover
Installation Instructions
3. Using an UNPLUGGED, UL-approved,
Neutral
(center wire)
4. Attach the remaining two power cord
Access
cover screw
DO NOT
REMOVE
THIS SCREW
5. Reinstall the terminal block cover.
Access cover
screw
Access cover
screw
30 amp. power cord, NEMA 10-30 type
SRDT, attach the neutral (center wire)
conductor to the SILVER colored center
terminal on the terminal block. Tighten the
screw securely.
Neutral Silver Terminal
outer conductors to the outer, BRASS
colored terminals on the terminal block.
Tighten both screws securely.
Outer
Brass
Terminals
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/
conductor at connections.
WARNING
ELECTRICAL SHOCK HAZARD
Do not operate dryer without terminal cover
in place. A correctly installed terminal block
cover also acts a qualified strain relief for the
power cord.
9
DO NOT
move
internal
ground in
a 3-wire
system!
DO NOT
move
internal
ground in
a 3-wire
system!