Electrolux 136936003 Instructions D'installation page 11

Sécheuse á chargement frontal
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Move the internal (WHITE) dryer harness
wire to the terminal block and attach it
along with the neutral (WHITE) power cord
wire conductor to the center, SILVER
colored terminal on the terminal block.
Tighten the screw securely.
WHITE
harness
wire
WHITE
neutral
wire
6. Attach the RED and BLACK power cord
conductors to the outer, BRASS colored
terminals on the terminal block. Tighten
both screws securely.
Brass
Terminal
BLACK or
RED
power wire
7. Reinstall the terminal block cover.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/
conductor at connections.
WARNING
ELECTRICAL SHOCK HAZARD
Do not operate dryer without terminal cover
in place. A correctly installed terminal block
cover also acts a qualified strain relief for the
power cord.
Installation Instructions
Neutral
silver
terminal
Brass
Terminal
BLACK or RED
power wire
Direct Drain Kit (on some
models)
If your model included a direct drain kit, you
may follow the instructions below to install it
on your dryer for convenient drainage of your
dryer's condensed water.
1. Locate the red tubing and plastic fitting on
the back of the dryer.
2. With a pair of pliers, release the hose
clamp and remove the tubing from the
plastic fitting.
3. Retrieve the 90 degree plastic elbow from
the direct drain installation kit that came
with your dryer and install it onto the red
tubing.
11

Publicité

Table des Matières
loading

Table des Matières